Hunt County heating and cooling, county by county: 840 square miles of Texas lying northeast of the Dallas–Fort Worth metro's centre, 10 ZIP codes, and a climate record read from DALLAS LOVE FLD, TX US. TempReach USA connects you with an independent local HVAC technician; this page sets out the county's own figures.
Call center hours: Mon-Fri 7:00 AM-10:00 PM ET | Sat 8:00 AM-10:00 PM ET | Sun 7:00 AM-9:00 PM ET
Start here if you read nothing else: this page covers Hunt County, Texas — 840 square miles, 0 listed communities, a centroid northeast of the Dallas–Fort Worth metro's centre. Its climate record, from DALLAS LOVE FLD, TX US, sets a cooling pressure on its systems. TempReach USA publishes the homework and routes the call; an independent local HVAC technician serving the county does the work.
The station for this county's metro is DALLAS LOVE FLD, TX US, and its NOAA 1991-2020 normals are the source of every figure in this section. Precipitation averages 38.32 inches a year; the temperature record averages 68.0 degrees, built from 107.5 days at 90 or above and 23.1 nights at or below freezing; the workload totals 1,992 heating degree days and 3,125 cooling degree days. Hunt County is read through that record throughout this page.
Cooling writes this county's HVAC calendar. With 3,125 cooling degree days against 1,992 heating degree days in the normals recorded at DALLAS LOVE FLD, TX US, the systems across Hunt County spend their lives working the hot half of the year: condensers cycling through 107.5 days at 90 degrees or more, coils pulling moisture out of the air for month after month. The pressure shows up as midsummer breakdowns, capacities fading on the oldest equipment first, and a maintenance calendar that has to be kept in spring — because by the time the heat arrives, the county's systems are already on stage.
Distance is the county fact the climate table leaves out. Hunt County's centroid lies northeast of the Dallas–Fort Worth metro's centre, roughly 52 miles from the centre it is measured against, and that distance is travelled on every call routed here — out through the metro's nearer counties and into this one's 10 ZIP codes. Local knowledge in a county like this is partly a map held in the head: which roads, which communities, which end of the county a call is coming from.
Routing in Hunt County is written in five digits. The county's codes begin at 75135 and run to 75496, 10 in total, and between the first and the last sits the county's full spread of ground — 840 square miles from the metro-facing edge to the far side. A technician's week here is a tour of those codes, and the tour is also a tour of the county's building history, because each code's systems were largely fitted when that code's streets were built.
Neighbouring counties are the honest context for Hunt County's figures. Its 840 square miles sit inside a wider spread of county ground — Rockwall County, Tarrant County, Wise County are among the 10 neighbours on its record — and its position northeast of the Dallas–Fort Worth metro's centre places it on its own side of that spread. A system near the county's edge may be closer to a neighbouring county's centre than to its own; the pages are organised by county because the data is, and the links between them carry the rest of the picture.
Consider what one year asks of a system in Hunt County: a cooling season measured at 3,125 degree days, a heating season at 1,992, 107.5 days of serious heat and 23.1 freezing nights, and 38.32 inches of precipitation working on every outdoor unit through all of it. No single figure is remarkable; the combination is the county's climate, and it is the combination a system has to survive for fifteen or twenty years. The service patterns described on this page are that arithmetic, playing out across 840 square miles of housing.
The codes carry the community story in Hunt County: 10 of them, from 75135 through to 75496, at 84.0 square miles per code across the county's 840 square miles. Nobody here describes a call by its town, because the record gives the county no towns to describe it by; they describe it by its code and its road. The housing behind those codes was still built decade by decade, and the systems still age decade by decade — the county simply files the diary by ZIP instead of by place.
Age is the county's second climate. The Dallas–Fort Worth metro's median home was built in 1992, and 31.0% of its homes predate 1980 — in Hunt County, that share is the older districts and the long-settled communities, where ductwork from an earlier equipment era still serves replacement systems. The newer share, 38.1% built since 2000, concentrates in the county's growth edges. The service diary divides along that line: deep equipment-and-duct conversations at the old end, first-replacement and control conversations at the new one.
A reader who only had Hunt County's identifying figures would already know its shape: a county of 840 square miles in Texas, 10 ZIP codes, 0 communities on the record, sitting northeast of the Dallas–Fort Worth metro's centre. What the figures cannot say alone is how the ground feels to work — the drives between calls, the mix of decades in the housing, the season that runs taller — and that is what the rest of this page is for, section by section.
City pages carry the metro-wide homework — housing eras, the problem ranking, services in depth. This county sits inside their coverage.
TempReach USA is not an HVAC company. We employ no heating or cooling technicians, we run no service trucks, and we do not carry out HVAC work of any kind. This website and its call center exist for one purpose: to connect homeowners with independent local heating and cooling professionals who serve their area. When you call the number on this site, your call is routed to such a professional. From that point, everything about the job belongs to that professional and to you: the assessment, the work itself, the scheduling, what you are charged, and the terms of any agreement you reach. The professional who takes your job is solely responsible for it. The technician who arrives at your home runs their own business; they are not an employee, agent or subcontractor of TempReach USA. Our part is the information on these pages — assembled from Census Bureau housing data and NOAA climate records for each metro — and the routing of your call. We state this plainly on purpose: you should know exactly who you are hiring before anyone picks up a wrench or a gauge.
One call connects you with an independent local heating and cooling professional serving Hunt County and the Dallas–Fort Worth metro.
Call center hours: Mon-Fri 7:00 AM-10:00 PM ET | Sat 8:00 AM-10:00 PM ET | Sun 7:00 AM-9:00 PM ET